热态下鼓泡浆液反应器的气含率研究

本文在热态条件下，研究了鼓泡浆液反应器的气含率、反应器直径为0.098m，物系组成为氮气－液体石腊－石英砂。考察了气速、压力、温度、静床高及固体引入等因素对气含率的影响。对于53μm粒子的三相浆态体系，气含率与表观气速关系式为εG=0.053uG^1.2。     

微波法合成葡萄糖三聚氰胺树脂胶黏剂

合成了一种不含甲醛、无毒的绿色环保型胶黏剂.以葡萄糖代替甲醛,在酸性条件下用微波法合成了类似于脲醛树脂的绿色环保型葡萄糖三聚氰胺树脂,通过正交实验法获得了合成的最佳条件,同时对树脂的固化条件进行了研究.葡萄糖三聚氰胺树脂合成的最佳反应条件为:pH=3,催化剂用量:0.40g,n(三聚氰胺)∶n(葡萄糖)=4∶0.3,反应时间:6min.催化剂用量和反应配比对葡萄糖三聚氰胺树脂的合成反应的影响较大,其次是pH值,对反应影响最小的是反应时间.但反应时间也不应过长,以免碳化.     

提高复合塔板操作弹性和通量研究

在内径为 5 0 0mm和 30 0mm的塔内 ,以空气 水为物系 ,测定了不同结构 (浮阀 筛孔穿流板、非均匀开孔率穿流板、双孔径穿流板 )的穿流板与 2 5 0Y规整填料组成的各种复合塔板的流体力学性能。试验结果表明 :浮阀 筛孔复合塔板操作弹性小、气液处理量小 ;非均匀板复合塔板与均匀板复合塔板相比 ,操作弹性大2 0 %— 6 0 % ,气处理量大 2 0 %— 80 % ,液处理量大 70 %左右 ;双孔径复合塔板比单孔径复合塔板处理量略微增大 ,操作弹性高达 3.5以上。     

Recent studies of self-condensation and co-condensation of melamine-formaldehyde resins; cure at low temperatures

Self-condensation: recent research on the chemical pathways by which alcoholated melamine-formaldehyde (MF) resins react with themselves and on the product structures is summarized. Model compound studies suggest that bridges are less stable than widely thought unless they are in hexahydro-1,3,5-triazine ring structures. In acyclic structures they are probably less stable than bridges. Co-condensation: studies of how the composition of MF resins influences the rates of reaction with poly(ol) co-reactant show that MF resins that contain very low levels of and/or functionality are quite reactive. Reactivities of a variety of poly(ester) and acrylic coreactants were studied. By combining reactive MF resins with reactive co-reactants one can formulate high solids enamels that cure by co-condensation in 30 min at 50 to 65 °C with 0.5 parts per hundred (phr) of p-toluenesulfonic acid (p-TSA) catalyst. Cure at 25 °C appears feasible with higher catalyst levels.     

Gas hold-up in non-newtonian solutions in a bubble column with internals

Bubble characteristics and gas hold-up were studied in a two phase (air-aqueous CMC solution) bubble column provided with helical coils and straight tubes as internals. The effects of superficial gas velocity, rheological properties, and volume fraction covered by the internals, on gas hold-up were studied. Hold-up values determined directly and by simultaneous pressure drop measurements matched well. Enhancement of gas hold-up values up to 55 per cent was achieved in systems using internals. The gas hold-up results were also compared with the values obtained from correlations reported in the literature.     

2种高剪切搅拌器流动特性的CFD模拟

采用计算流体力学模拟方法对2种用于分散混合过程的高剪切搅拌器的流动特性进行研究分析,分别是转子定子搅拌器(RS)和多级叶轮式搅拌釜(CF)。本文从流场细节和功率消耗方面对其进行考察研究,从而为解释搅拌器中气泡的分散混合过程提供理论依据。模拟结果表明,在RS中流体大致呈周向流动,且剪切速率分布相对较为均匀,较高剪切速率不仅出现在转子到壁面的径向间隙处,而且出现在转子与定子之间的轴向间隙处:而在CF中,流体呈现较为明显的旋转流动,且剪切速率分布没有RS均匀,较高的剪切速率只出现在叶轮与壁面的径向间隙处。在相同转速下,虽然这2种搅拌器所形成的平均剪切速率差别不大,但CF中所形成的最大剪切速率大于RS,这也意味着相同操作条件下CF中所能形成的气泡尺寸更小,这与实验结果是一致的。对于这2种搅拌器,在层流区功率准数与搅拌雷诺数都成反比,且CFD模拟计算得到的结果与根据实验得到的关联式的结果基本一致。然而CF的功率消耗高于RS的功率消耗。     

塔板结构参数对负荷性能曲线的影响

通过对板式塔流体力学性能的分析，找出了板式塔塔板结构参数对负荷性能图中负荷性能曲线的影响关系，可用于指导板式塔的优化设计和改造。     

精细化学品间歇精馏塔的改进及应用

在间歇精馏釜内具气液分布器,并增设持液收集器,使在精馏末期的填料层持液不与釜内已提纯的纯组分相混合,减少塔顶产品损失,可省时又节能。实践证明该技术在化学工业中很有推广应用价值。     

三聚氰胺氰尿酸盐阻燃聚氨酯硬泡

将三聚氰胺氰尿酸盐(MCA)作为阻燃剂,采用一步全水发泡法,制备一系列硬质聚氨酯泡沫/三聚氰胺氰尿酸盐复合材料(RPUF/MCA),采用扫描电子显微镜(SEM)、热重分析(TG)、极限氧指数(LOI)、UL-94垂直燃烧、烟密度测试、傅立叶红外光谱(FT-IR)及拉曼光谱表征,研究了MCA对硬质聚氨酯泡沫(RPUF)泡孔结构、热稳定性、阻燃性及燃烧烟气密度的影响。研究表明,MCA能够显著提高RPUF/MCA的阻燃性能,30份的MCA使RPUF/MCA30达到UL-94 V-1级别,极限氧指数达到22.0%。热重测试结果表明,MCA的添加使成炭率降低;同时发现,MCA的添加降低了RPUF/MCA泡沫复合材料的初始热分解温度和复合材料的燃烧烟气密度,有效地提高了复合材料火灾安全性能。